hedwigaihedwigaihedwigai

Steer a walking robot

Continue in

biped_Laika is Lucen Robotics’ walking robot, with six motors in each leg. Here Lucen’s own walking policy walks it in the MuJoCo simulator. You set how fast it goes and turns, and the policy places every step. The robot, the policy and the control code come unchanged from Lucen’s open SDK.

Watch

Drawn from Lucen’s model. Drag to look around; double-click to go back.

Loading the robot…

Every link where the simulator put it, 25 times a second. The blue line is the way it walked.

1. Start it

Sign in to run

You steer the robot for up to a minute; new accounts get three free walks.

$0.01 a walk of up to 60 seconds. A walk stopped in its first 5 seconds is free.

Actuator and policy: Lucen’s reference setting, walk.onnx

The walk uses the setting Lucen checks its policies with in simulation: the policy’s output times 0.8, and 2 control steps (40 ms) between a target and the motor acting on it. Change any of it here before you start. The values are multiples of the motors’ own. What each one does to the walk.

Delaytrained on 0–3 steps
PolicyONNX, at most 8 MB

Without a file the robot walks Lucen’s walk.onnx. Your own must be stamped with Lucen’s contract (python tools/onnx_manifest.py --stamp POLICY.onnx --profile PROFILE in lucen-sdk). An unstamped policy does not run and is not charged.

2. Steer it

Hold W or to walk forward, S or back, A D or to turn, Q E to step sideways. Let go and it walks in place.

3. What it is doing

You ask for
0.00 m/s, turn 0.00 rad/s
The policy is told
–
It walks
–
Actuator, policy
–
So far
–

A command reaches the robot a second or two after you press. The policy was trained for up to 0.2 m/s forward, 0.1 m/s sideways and 0.3 rad/s turning. How it walks is measured over the last second.